Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
blog:models_3d_lunagans [2021/07/23 15:18] – [In-Progress Images] john | blog:models_3d_lunagans [2021/08/05 13:47] – [In-Progress Images] john | ||
---|---|---|---|
Line 15: | Line 15: | ||
* Scaling: Model is designed for 1/20 scale, but had to be scaled down to 80% for the largest part (the ' | * Scaling: Model is designed for 1/20 scale, but had to be scaled down to 80% for the largest part (the ' | ||
* Supports: Added by Chitubox, plus manual positioning | * Supports: Added by Chitubox, plus manual positioning | ||
+ | |||
+ | ===== Tools Used ===== | ||
+ | |||
+ | * Elegoo Mars Pro SLA LCD printer | ||
+ | * Elegoo standard photo-polymer resin (grey) | ||
+ | * Ultimate sanding sticks | ||
+ | * Pin drill | ||
+ | * Loctite super glue | ||
+ | * Various diameters of brass pipe & wire | ||
+ | |||
+ | ===== Colours Used ===== | ||
+ | |||
+ | * Base primer: Vallejo Surface Primer, black. | ||
+ | |||
+ | ===== Background Info ===== | ||
+ | |||
===== 3D Model ====== | ===== 3D Model ====== | ||
Line 221: | Line 237: | ||
I'm happy with the seam on the two central sections, the lower hull looks okay too, the only bit that needs a little more work is the head, and it is mainly the underside and a small section on the rear. A small amount of work with a finer file should resolve it. | I'm happy with the seam on the two central sections, the lower hull looks okay too, the only bit that needs a little more work is the head, and it is mainly the underside and a small section on the rear. A small amount of work with a finer file should resolve it. | ||
+ | |||
+ | **[Update - 1st August 2021]** - Final primer and pre-shading of all the parts, ready for base colour to be applied //(which will probably be a light grey or off-white)//: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | All the major parts are drilled and ready to be glued and pinned at this point, so there shouldn' | ||
+ | |||
+ | **[Update - 4th August 2021]** - Applied an //initial// shading layer (MIG Ammo, Light Grey) to the lower hull, head (bottom half only) and one of the legs: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | These will get some lighter highlights and then some mid-grey camo patterns added. | ||
===== Finished Images ===== | ===== Finished Images ===== |