Differences

This shows you the differences between two versions of the page.

--- blog:personal_diy_computer_shelving [2020/07/26 09:26] – john
+++ blog:personal_diy_computer_shelving [2020/07/26 09:34] – [Computers Installed] john
@@ Line 1: / Line 1: @@
 ===== Shelving for Retro Computer Base units =====
-Made this short free-standing shelving unit to house various retro-computer base units.
+**[July 2020]**
+I built this short free-standing shelving unit to house various retro-computer base units which had been standing on the floor since moving to the new (smaller) office room.
 {{:blog:img_1512.jpg?400|}} {{:blog:img_1514.jpg?400|}} {{:blog:img_1515.jpg?400|}}
+It's build from 5 identical shelves (51cm x 40cm) from [[https://www.merseymdfplasandply.co.uk/|Mersey Plas & Ply]], which I've used a couple of times for custom-sized shelving panels, along with a few bits of MDF offcuts I had in the shed, and about a dozen wood screws. Total cost was around £30 to build.
 ==== Computers Installed ====
-{{:blog:img_1519.jpg?400|}} {{:blog:img_1520.jpg?400|}} {{:blog:img_1521.jpg?400|}}
+It turned out quite nicely for a relatively cheap solution. Here's (from top to bottom):
+   * Sharp X68000 Pro
+   * NEC PC-9821An
+   * Macintosh IICi
+   * Acorn Risc PC700
+{{:blog:img_1519.jpg?400|}} {{:blog:img_1520.jpg?400|}}
+... and here's the 'computer' corner of the office, with most of the 8/16bit microcomputers:
+{{:blog:img_1521.jpg?400|}}
+It certainly looks a lot tidier than the old setup which had them stacked on top of each other on the floor. As a bonus all of the cabling from the back of the systems is now hidden, too.