Differences

This shows you the differences between two versions of the page.

--- blog:286_shootout_pa286-sa1 [2021/01/20 08:15] – [Oscillator Modification] john
+++ blog:286_shootout_pa286-sa1 [2024/02/16 19:02] (current) – [Conclusion] john
@@ Line 1: / Line 1: @@
 ====== Peaktron / Micro Systems PA286-SA1 ======
+{{:blog:img20210115115936.jpg?150|}}
+A 286 motherboard that seemed promising. Information on specifications and configuration, as well as benchmarks and testing.
 ===== Initial Thoughts =====
@@ Line 133: / Line 136: @@
 The board has a soldered-in oscillator of 32MHz, giving a 16MHz processor clock. To do any performance tuning or use a 20MHz or faster processor, it will have to be replaced with a socket:
-{{:blog:img20210116110901.jpg?200 |}}{{:blog:img20210116121004.jpg?200 |}}{{:blog:img20210116121019.jpg?200 |}}
+{{:blog:img20210116110901.jpg?200|}}{{:blog:img20210116121004.jpg?200|}}{{:blog:img20210116121019.jpg?200|}}
-{{:blog:img20210116121136.jpg?200 |}}{{:blog:img20210116122204.jpg?200 |}}
+{{:blog:img20210116121136.jpg?200|}}{{:blog:img20210116122204.jpg?200|}}
+The board works correctly again with the original oscillator in the socket.
 ===== 0 Wait State =====
@@ Line 295: / Line 300: @@
 ===== Conclusion =====
-This one looked too good to be true: 20MHz support, 16MB RAM support, modern-single-chip chipset, performance options (0-wait state, BIOS shadowing, etc). Unfortunately it simply //was// too good to be true.
+This one looked too good to be true: 20MHz support, 16MB RAM support, performance options (0-wait state, BIOS shadowing, etc). Unfortunately it simply //was// too good to be true.
 The board is well made, clean and nicely finished... but... it simply can't run reliably with 0-wait state mode enabled; and that is absolutely essential for decent performance. Running in 1-wait state mode with a 16MHz processor speed drops the overall performance to that of a 10 or 12MHz processor (12MHz is being generous).