Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
blog:911_exhaust [2022/08/14 17:40] – [Removing Catalytic Converter / Turbo] john | blog:911_exhaust [2022/08/17 15:22] (current) – [Repairing & Repainting Parts] john | ||
---|---|---|---|
Line 224: | Line 224: | ||
===== Repairing & Repainting Parts ===== | ===== Repairing & Repainting Parts ===== | ||
+ | |||
+ | First of all, cleaning the bumper brackets, engine tin, supports and hot air ducts: | ||
+ | |||
+ | **Blasting & Cleaning** | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **Primer** | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | The rear engine tin panel is the only part that needs a repair. Fortunately everything else cleaned up well. | ||
+ | |||
+ | **Paint & Clear Coat** | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Blower motors are fine, but dirty and a little corroded, so they were stripped down, cleaned, new screws and washers fitted and given a coat of clear lacquer to try to keep them from rusting any further: | ||
+ | |||
+ | **Stripping Blowers** | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **Cleaned, sprayed and re-assembled** | ||
+ | |||
+ | {{: | ||
===== Replacing Gaskets & Seals ===== | ===== Replacing Gaskets & Seals ===== |