Differences

This shows you the differences between two versions of the page.

--- blog:escort:work [2024/08/04 18:44] – [Escort Work Log] john
+++ blog:escort:work [2024/08/04 19:09] (current) – [Other Technical Info] john
@@ Line 4: / Line 4: @@
 |                                                                                          | [[blog:escort:work:fuelling_reset|2024 / August]] | Fuelling Reset - resetting CO/Mixture and idle speed |
 | [[blog:escort:work:lift_pump|{{:blog:escort:work:lift_pump:img20240725151959.jpg?75}}]]  | [[blog:escort:work:lift_pump|2024 / July]]  | Fuel system overhaul - lift pump and swirl tank  |
+==== To-Do List ====
+A reminder of jobs still to do:
+   * Replace ISCV valve, connect wideband O2 sensor and reset base fuelling
+   * Fit AEM AFR sensor pod on side of tunnel for O2 sensor
+   * Refit front struct brace
+   * Remove temporary fuel pressure gauge from engine bay
+   * Remove restrictor from 'R' port on Amal boost valve & re-adjust actuator for 20-25psi
+   * Reseal front and rear windows
+   * Additional vertical bracing for Corsa EPS column
+   * Reshape Corsa column shroud to clear wheel boss
+   * Fabricate a lower column shroud to hide EPS motor etc
+   * Heat up headliner in corners to remove creases
+   * Tracking check
+   * Soften front & rear Gaz shocks
+   * Check brake servo
+   * Rubber isolate the water rail above the exhaust manifold so that it doesn't rub
+   * Fabricate a boot carpet set
+   * Check calibration of fuel level sender and gauge
 ==== Other Technical Info ====
@@ Line 29: / Line 50: @@
   * Corsa Power Steering
       * [[blog:escort:work:tech:corsa_eps_instructions|Controller instructions]]
+  * [[blog:escort:work:tech:afr_table|AFR to CO table]]