Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| blog:ontrack_install [2024/12/20 14:19] – [IBM PC - Drive Overlay Software Install (without floppy/cdrom)] john | blog:ontrack_install [2024/12/20 14:20] (current) – [Process] john | ||
|---|---|---|---|
| Line 14: | Line 14: | ||
| Connect the new hard drive to Linux. | Connect the new hard drive to Linux. | ||
| - | Find the device name of the USB drive (dmesg or lsblk) | + | Find the device name of the USB drive (dmesg or lsblk): e.g. **/ |
| Run a new emulation, with direct access to the new USB drive and the Ontrack boot floppy image. Assuming the USB adapter shows up as /// | Run a new emulation, with direct access to the new USB drive and the Ontrack boot floppy image. Assuming the USB adapter shows up as /// | ||
| - | <code> | + | > qemu-system-i386 -drive file=**/dev/sde**,format=raw -fda **ontrack-9.57.img** -boot menu=on |
| - | qemu-system-i386 -drive file=/ | + | |
| - | </ | + | |
| Install the Ontrack drive overlay. I usually go for a <2GB C: / primary partition and up to 120GB D: / secondary partition on a typical 120GB SSD. | Install the Ontrack drive overlay. I usually go for a <2GB C: / primary partition and up to 120GB D: / secondary partition on a typical 120GB SSD. | ||
| Line 26: | Line 24: | ||
| Close the emulated system down. Replace the ontrack boot floppy with the Windows 98SE boot floppy: | Close the emulated system down. Replace the ontrack boot floppy with the Windows 98SE boot floppy: | ||
| - | <code> | + | > qemu-system-i386 -drive file=**/dev/sde**,format=raw -fda **win98se.img** -boot menu=on |
| - | qemu-system-i386 -drive file=/ | + | |
| - | </ | + | |
| - | Boot the Win 98SE command line rescue disk. Format, | + | Boot the Win 98SE command line rescue disk. //sys// the new partition to make it a bootable DOS system: |
| < | < | ||