MT32-Pi, 386 Installation

In short: Put a virtual one of these:

Inside this:

In more detail: The emulation of the Roland MT-32 has come on significantly in recent years, with the Munt project releasing a very accurate software emulation of the device - good enough for most purposes.

More recently, a project to run the Munt emulator on a Raspberry Pi (on 'bare metal', i.e. no Linux OS to boot), called MT32-pi, has reached a milestone where packaging a working MT-32 emulator on a device that can fit in the palm of your hand is possible.

Lots of people are now building these devices, packaging them in to small instrument cases or similar. However, I really liked the idea of having one or two computers where all of the MIDI functionality was entirely built-in, and not reliant on external boxes or power supplies. “Hmm…” I thought; “…that 5.25 drive bay looks like just the place I could fit such a device”.

• Raspberry Pi 3B
• 20×2 alphanumeric LCD display
  • https://www.buydisplay.com/character-lcd-display-module/20x2-character
• M-Audio Uno USB MIDI interface
  • USB input to the Pi, provides one MIDI IN (to accept input from the PC's MIDI card OUT), one MIDI OUT (not needed at present).
  • https://m-audio.com/products/view/uno
• 5.25“ PC disk drive drawer
  • To fit the device inside the PC neatly, you could also fasten it to the back of a 3d-printed 5.25” blanking plate if you had the facilities
  • https://www.amazon.co.uk/IOCrest-SY-ACC65085-5-25-Inch-Computer-Accessories/dp/B01LY3YDLN/ref=sr_1_7?dchild=1&keywords=disk+drive+drawer&qid=1621843403&sr=8-7
• Rotary encoder
  • Used to control device volume/navigate menus
  • Any relatively standard 5-pin controller should work
• Two momentary push buttons
  • At least 2 buttons are needed - one to switch between MT-32 and Soundfont mode, and one to select the type of MT-32 or soundfont being used
  • Not latching
• Micro-USB to 4-pin PC 'Molex' power connector
  • To power the Pi from the standard PC disk drive connector
• Innomaker HiFi DAC 'hat'
  • https://www.inno-maker.com/product/hifi-dac-hat/
• Stereo phono cable (HiFi DAC end) to MPC-2 CD audio 'in' cable (Soundblaster 16 end)
  • This can be made up with a simple 1×4 dupont plug to go on the sound card end of the phono cable