Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
blog:386_shootout_forex [2021/03/12 21:35] – [Initial Testing] john | blog:386_shootout_forex [2021/04/20 10:16] (current) – [Initial Testing] john | ||
---|---|---|---|
Line 73: | Line 73: | ||
These UMB regions can then be used to load drivers and TSR's high, using the //highdvr// and //hightsr// utility included with The Last Byte memory manager similar to the MS-DOS commands // | These UMB regions can then be used to load drivers and TSR's high, using the //highdvr// and //hightsr// utility included with The Last Byte memory manager similar to the MS-DOS commands // | ||
+ | === BIOS === | ||
+ | |||
+ | BIOS from my motherboard: | ||
+ | |||
+ | * {{ : | ||
===== Repairs ===== | ===== Repairs ===== | ||
Line 134: | Line 139: | ||
**[Update - 12/ | **[Update - 12/ | ||
- | After initially having to repair two broken LED's on the card, I eventually got it working and up and running in the Forex board. It confirmed that all voltages were present, and that the system reset behaviour was working, but no error codes are present: | + | After initially having to repair two broken LED's on the __new__ diagnostic |
{{: | {{: | ||
+ | |||
+ | Not sure how to proceed from here..... | ||
===== Configuration ===== | ===== Configuration ===== | ||