This is an old revision of the document!

I picked up this old PET-2001 from a clear-out of old electronic waste a colleague was doing at work. It had been stored in the back of a workshop along with old toner cartridges, ancient CRT monitors, 10base network switches, 286 laptops and more, that were all destined for waste disposal.

Although it looked pretty beat up, it seems to be mainly dirt/sticker residue - the case is in pretty good condition apart from a few minor scuffs on the corners.

Internally, it is surprisingly clean, with just a little dust on the board. The transformer is also very clean with no corrosion that seems typical for these computers. Also no damaged caps or traces on the board, which is promising.

It also has an add-on board fitted, piggy-backed on a ROM socket. This turns out to be a SuperSoft HR40 High Resolution board, which provides a 320×200 pixel drawing interface on 40-column PET displays; normally the PET cannot draw pixels at all and is restricted to character display… so this is quite an interesting find.

There's a project to reverse engineer this board on Github.

Towards the rear IO edge connectors, the board is a little more dirty, where it has been open to the elements/dust. In the far corner there is a very small amount of surface rust that will need taking care of.

After re-wiring the UK mains plug (which had become frayed and loose), I checked the fuse in the PSU and powered the system on. Initially I got no response at all and ended up pulling out the multimeter to check mainboard DC voltages… at least a nominal +5v DC and more were present, so my heart was starting to sink at the prospect of the monitor being faulty… but no!…. it was simply that the brightness had somehow been turned all the way down! m(

Turning it about half way up then showed the little PET sitting at a perfectly normal Commodore BASIC prompt:

  • blog/commodore_pet_restoration.1637839090.txt.gz
  • Last modified: 2021/11/25 11:18
  • by john