blog:models_3d_lunagans

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
blog:models_3d_lunagans [2021/07/23 20:33] – [Tools Used] johnblog:models_3d_lunagans [2021/08/06 12:46] (current) – [Maschinen Krieger Luna Gans/LF-06] john
Line 1: Line 1:
-====== Maschinen Krieger Luna Gans/LF-06 ======+====== Maschinen Krieger Luna Gans ======
  
 This is another design from the Maschinen Krieger universe, modified by the artist 'Three Triangle'. It's not an exact duplicate of the Wave/Hasegawa model, but pretty close and definitely 'in spirit' of the design. This is another design from the Maschinen Krieger universe, modified by the artist 'Three Triangle'. It's not an exact duplicate of the Wave/Hasegawa model, but pretty close and definitely 'in spirit' of the design.
Line 28: Line 28:
  
    * Base primer: Vallejo Surface Primer, black.    * Base primer: Vallejo Surface Primer, black.
 +
 +===== Background Info =====
 +
 +
 ===== 3D Model ====== ===== 3D Model ======
  
Line 233: Line 237:
  
 I'm happy with the seam on the two central sections, the lower hull looks okay too, the only bit that needs a little more work is the head, and it is mainly the underside and a small section on the rear. A small amount of work with a finer file should resolve it. I'm happy with the seam on the two central sections, the lower hull looks okay too, the only bit that needs a little more work is the head, and it is mainly the underside and a small section on the rear. A small amount of work with a finer file should resolve it.
 +
 +**[Update - 1st August 2021]** - Final primer and pre-shading of all the parts, ready for base colour to be applied //(which will probably be a light grey or off-white)//:
 +
 +{{:blog:models:img20210801190538.jpg?400|}} {{:blog:models:img20210801200456.jpg?400|}}
 +
 +All the major parts are drilled and ready to be glued and pinned at this point, so there shouldn't be any drilling needed once the final paint colours are applied. I'm using the technique I use with most of my Gundam models, in that I'm leaving all of the sub-components seperate and painting them before assembling. Weathering etc will be done once the model is fully assembled, but I learned from painting the first 3D resin print, the [[:blog:models_friedrich_lfs03b|Ma.K Friedrich]] that my airbrush and detailing techniques don't lend themselves to fine control on assembled models!
 +
 +**[Update - 4th August 2021]** - Applied an //initial// shading layer (MIG Ammo, Light Grey) to the lower hull, head (bottom half only) and one of the legs:
 +
 +{{:blog:models:img_2184.jpg?500|}} {{:blog:models:img_2185.jpg?220|}}
 +
 +These will get some lighter highlights and then some mid-grey camo patterns added.
 ===== Finished Images ===== ===== Finished Images =====
  • blog/models_3d_lunagans.1627068836.txt.gz
  • Last modified: 2021/07/23 20:33
  • by john