Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
blog:personal_diy_bosch_drill [2020/11/12 12:30] – john | blog:personal_diy_bosch_drill [2020/11/12 12:33] (current) – john | ||
---|---|---|---|
Line 23: | Line 23: | ||
Above; removing the gearbox, chuck and selection mechanism of the old, burnt-out drill. | Above; removing the gearbox, chuck and selection mechanism of the old, burnt-out drill. | ||
- | {{:blog: | + | Below; removing the gearbox and chuck of the new non-hammer drill: |
- | {{:blog:img20201112121203.jpg?200|}} {{: | + | {{:blog:img20201112120928.jpg?400|}} |
- | {{: | + | Below; fitting the gearbox, chuck and selector from the old hammer drill into the new case and fitting on the new motor: |
+ | |||
+ | {{: | ||
+ | |||
+ | New drill fitted with the hammer mechanism from the old one: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | At some point, if I can get a replacement motor, I'll refit it into the old drill and then have a working drill/ |