Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
blog:personal_diy_rollerdoor [2021/01/04 09:05] – created john | blog:personal_diy_rollerdoor [2021/01/04 09:15] (current) – john | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Insulating Garage Door ======= | ====== Insulating Garage Door ======= | ||
+ | |||
+ | As part of getting the new garage door installed in 2020, we had various options for the spec of the installation; | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ... however, the particular features of our installation meant that after the roller door was installed, there was a significant gap between the top of the roller and the garage brickwork, and this was letting quite a draft in. Fortunately I had load of hardboard panels left from lining the garage loft roof and made up something that was approximately the same as the £700 motor enclosure option: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | All edges, including from the floor, sealed with either caulk or expanding foam, so the draft was cut down substantially. | ||
+ | |||
+ | The sagging of the panels was sorted by added a set of bent steel ' | ||
+ | |||
+ | {{: | ||
+ | |||
+ | The only other thing to do now would be to install some wide draft-excluder brushes on the bottom edge of the enclosure so that it physically touches the rear of the roller door. |