Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| blog:escort:work [2024/07/26 20:44] – [Table] john | blog:escort:work [2024/08/04 19:09] (current) – [Other Technical Info] john | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ^ Image ^ Date ^ Title ^ | ^ Image ^ Date ^ Title ^ | ||
| + | | | [[blog: | ||
| | [[blog: | | [[blog: | ||
| + | |||
| + | ==== To-Do List ==== | ||
| + | |||
| + | A reminder of jobs still to do: | ||
| + | |||
| + | * Replace ISCV valve, connect wideband O2 sensor and reset base fuelling | ||
| + | * Fit AEM AFR sensor pod on side of tunnel for O2 sensor | ||
| + | * Refit front struct brace | ||
| + | * Remove temporary fuel pressure gauge from engine bay | ||
| + | * Remove restrictor from ' | ||
| + | * Reseal front and rear windows | ||
| + | * Additional vertical bracing for Corsa EPS column | ||
| + | * Reshape Corsa column shroud to clear wheel boss | ||
| + | * Fabricate a lower column shroud to hide EPS motor etc | ||
| + | * Heat up headliner in corners to remove creases | ||
| + | * Tracking check | ||
| + | * Soften front & rear Gaz shocks | ||
| + | * Check brake servo | ||
| + | * Rubber isolate the water rail above the exhaust manifold so that it doesn' | ||
| + | * Fabricate a boot carpet set | ||
| + | * Check calibration of fuel level sender and gauge | ||
| ==== Other Technical Info ==== | ==== Other Technical Info ==== | ||
| Line 16: | Line 38: | ||
| * Stack gauges | * Stack gauges | ||
| * Clubman tachometer | * Clubman tachometer | ||
| - | * Speedo | + | * Speedometer - including calibration routine |
| * Boost | * Boost | ||
| * Fuel | * Fuel | ||
| Line 28: | Line 50: | ||
| * Corsa Power Steering | * Corsa Power Steering | ||
| * [[blog: | * [[blog: | ||
| + | |||
| + | * [[blog: | ||