Differences

This shows you the differences between two versions of the page.

--- blog:models_3d_rx78_bust [2021/07/10 22:20] – [In-Progress Images] john
+++ blog:models_3d_rx78_bust [2021/07/11 12:41] (current) – [In-Progress Images] john
@@ Line 16: / Line 16: @@
    * Supports: Added by Chitubox
+===== 3D Model =====
+{{:blog:models:screenshot_from_2021-07-05_21-38-14.png?400|}}
+This was my first ever 3d print and I made some fairly obvious mistakes:
+   * Aligned a lot of the parts to be completely horizontal (result: resin doesn't drain properly)
+   * Used automatic supports only (result: some of the small parts are slightly warped)
+In future, it's best if parts are angled away from the build plate and lcd at anything up to 45 degrees. In addition, smaller parts do need supports!
 ===== Printing =====
@@ Line 45: / Line 55: @@
 {{:blog:models:img_2134.jpg?300|}}
-Most parts are looking pretty good - except the camera/fin (which has a warped bottom, rather than flat), and the base of the bust itself, which again is slightly bent, rather than flat. In hindsight those two parts should have been affixed directly to the build plate, rather than put on supports.
+Most parts are looking pretty good - except the camera/fin (which has a warped bottom, rather than flat), and the base of the bust itself, which again is slightly bent, rather than flat. In hindsight those two parts should have been <del>affixed directly to the build plate</del> angled to allow the resin to drain, rather than <del>put on supports</del> flat which allowed it to pool on the horizontal surface.
 Some basic cleanup of the head, fin and face plate: