Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
blog:models_3d_rx78_bust [2021/07/11 12:12] – [RX-78-2 Gundam fixed-pose figure bust] john | blog:models_3d_rx78_bust [2021/07/11 12:41] (current) – [In-Progress Images] john | ||
---|---|---|---|
Line 19: | Line 19: | ||
{{: | {{: | ||
+ | |||
+ | This was my first ever 3d print and I made some fairly obvious mistakes: | ||
+ | |||
+ | * Aligned a lot of the parts to be completely horizontal (result: resin doesn' | ||
+ | * Used automatic supports only (result: some of the small parts are slightly warped) | ||
+ | |||
+ | In future, it's best if parts are angled away from the build plate and lcd at anything up to 45 degrees. In addition, smaller parts do need supports! | ||
===== Printing ===== | ===== Printing ===== | ||
Line 48: | Line 55: | ||
{{: | {{: | ||
- | Most parts are looking pretty good - except the camera/fin (which has a warped bottom, rather than flat), and the base of the bust itself, which again is slightly bent, rather than flat. In hindsight those two parts should have been affixed directly to the build plate, rather than put on supports. | + | Most parts are looking pretty good - except the camera/fin (which has a warped bottom, rather than flat), and the base of the bust itself, which again is slightly bent, rather than flat. In hindsight those two parts should have been <del>affixed directly to the build plate</ |
Some basic cleanup of the head, fin and face plate: | Some basic cleanup of the head, fin and face plate: |