Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
blog:models_3d_rx78_bust [2021/07/11 12:15] – [3D Model] john | blog:models_3d_rx78_bust [2021/07/11 12:41] (current) – [In-Progress Images] john | ||
---|---|---|---|
Line 55: | Line 55: | ||
{{: | {{: | ||
- | Most parts are looking pretty good - except the camera/fin (which has a warped bottom, rather than flat), and the base of the bust itself, which again is slightly bent, rather than flat. In hindsight those two parts should have been affixed directly to the build plate, rather than put on supports. | + | Most parts are looking pretty good - except the camera/fin (which has a warped bottom, rather than flat), and the base of the bust itself, which again is slightly bent, rather than flat. In hindsight those two parts should have been <del>affixed directly to the build plate</ |
Some basic cleanup of the head, fin and face plate: | Some basic cleanup of the head, fin and face plate: |