Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
blog:personal_diy_rollerdoor [2021/01/04 09:12] – john | blog:personal_diy_rollerdoor [2021/01/04 09:15] (current) – john | ||
---|---|---|---|
Line 10: | Line 10: | ||
{{: | {{: | ||
+ | |||
+ | All edges, including from the floor, sealed with either caulk or expanding foam, so the draft was cut down substantially. | ||
+ | |||
+ | The sagging of the panels was sorted by added a set of bent steel ' | ||
{{: | {{: | ||
+ | |||
+ | The only other thing to do now would be to install some wide draft-excluder brushes on the bottom edge of the enclosure so that it physically touches the rear of the roller door. |